The manufacturer of powder coating cooling crusher tells you that powder machinery is an equipment that effectively connects a series of processes such as spraying, recycling, and powder supply. It is one of the tools needed for electrostatic powder spraying. The following powder coating cooling crusher manufacturers take you to take a look at the cleaning methods of powder machinery:

1. Cleaning of the cyclone screen: The powder coating cooling crusher manufacturer tells you to first connect the discharger to the flange interface and seal it with a flat carton shell or stainless steel plate under the action of induced wind. Blow the powder inside the sieve with a pure air source. Then disassemble and clean the sieve leaf holder of the cyclone sieve, disassemble the sieve leaf, use an adjustable wrench to clamp the cap nut, and the other person can turn the motor handle counterclockwise to push the sieve leaf out.
2. To clean the main and auxiliary mills, first blow it with a pure air source. The dust will be sucked into the dust removal frame by the induced draft fan. The powder adhering to the main and auxiliary mills needs to be wiped with acetone or thinner. Keep the inner surface of the main and auxiliary mills. Smooth and clean.
3. Cleaning of the cyclone separator: The powder coating cooling crusher manufacturer tells you to first remove the baffle at the flange interface of the discharger, and use a pure air source to blow off the powder on the inner wall of the cyclone separator, or it is recommended to use a high-power bucket for hotels The vacuum cleaner removes the powder adhering to the inner wall. Then disassemble the upper connection part of the cyclone separator, and clean the machine after taking it out.
4. Cleaning of the dust removal cabinet: When cleaning the dust removal cabinet, first turn off the induced draft fan and cut off the power supply. The powder coating cooling crusher manufacturer tells you to remove the powder attached to the dust bag during the cleaning process. Then, open the recycling powder discharge valve, and check after the powder is discharged and cleaned: first check whether the binding parts of the dust bag are not tightly bound. Then look at closing the discharge valve and sealing it tightly. Cover the discharge opening with a plastic bag, and seal it tightly with adhesive tape to ensure no air leakage. Then clean the dust at the seal of the dust removal door to ensure the goodness of the seal when it is closed.
5. The manufacturer of the powder coating cooling crusher tells you that every time the whole machine is cleaned, it must be checked for leaks. Use the candle method to strictly check the installation and connection positions of each part for air leakage to ensure the normal operation of the equipment.
The manufacturer of powder coating cooling crusher tells you that the fine particles in the powder coating of powder machinery are easy to accumulate on the head of the spray gun or the part of the pipe where the airflow direction changes after the coating equipment. On the coating, in the electrostatic spraying construction, the environmental dust problem should also be paid enough attention.