The manufacturer of MIC container mixer tells you that the design and selection of the mixing device is closely integrated with the purpose of the mixing operation. Various mixing processes need to be realized by the operation of different mixing devices. The MIC container mixer manufacturer tells you that when designing and selecting types, first determine the type of agitator, motor power, and mixing speed according to the purpose and requirements of the process for the mixing operation. Then select the reducer, frame, mixing shaft, shaft seal and other components. The specific steps are as follows:

1. According to the process conditions, mixing purpose and requirements, select the type of agitator. When selecting the type of agitator, you should fully grasp the dynamic characteristics of the agitator and the causal relationship between the flow state produced by the agitator during the mixing process and various mixing purposes.
2. According to the determined agitator type and the flow state generated by the agitator during the mixing process, the MIC container mixer manufacturer tells you the process control requirements for mixing time, sedimentation speed, and dispersion degree, through experimental means and computer simulation design , Determine the motor power, stirring speed, and the diameter of the stirrer.
3. According to the motor power, mixing speed and process conditions, select and determine the reducer model from the reducer selection table. The manufacturer of MIC container mixer tells you that if the reducer is selected according to the actual working torque, the actual working torque should be less than the allowable torque of the reducer.
4. According to the output shaft head d of the reducer and the support mode of the stirring shaft system, select the frame and coupling of the same model and specification as d.
5. Select the shaft seal type according to the size of the rack mixing shaft head, installation and accommodation space, working pressure, and working temperature.
6. The MIC container mixer manufacturer tells you to design and select the structure of the mixing shaft according to the installation form and structural requirements, and check its strength and rigidity.
If designed according to rigid shaft, n/nk≤0.7 under the condition of meeting the strength
If designed according to the flexible shaft, n/nk>=1.3 under the condition of meeting the strength
7. Choose to install the bottom cover, flange base or flange flange according to the nominal center inch DN of the rack, the type and pressure rating of the stirring shaft
8. According to the MIC container mixer manufacturer's instructions, determine whether to configure auxiliary supports according to the support and anti-vibration conditions.
In the above selection process, the manufacturer of MIC container mixer tells you that the combination and configuration of the mixing device can be referred to (a schematic diagram of the design selection process of the mixing device). The key size of the connection between the components during the configuration process is the shaft head size, and the shaft head size is consistent. In principle, the components can be interchanged and combined.